LED Street light Installation Instruction

Using and installation instructions

1、Installation Procedures

【1】With 6 mm Allen wrench Loosen the screw

【2】Install lamp standard diameter of 50 mm

【3】Lock screw

【4】Connect Live Wire/Null Wire/Ground Wire to electric cable properly and switch on.

【1】Open 4PCS Steel hook entirely

【2】 Open lamp housing，note to the open the underprop, Make sure of the underprop stand   straightly, as figure

【3】 twist the screw pole loose

【4】 put the lamp pole through the waterproof ring，Lamp pole diameter of 60 mm

【5】 twist tight 4 pcs of screw to fixing the lamp pole

【6】 Connect Live Wire/Null Wire/Ground Wire to electric cable properly and switch on.

【1】The product contains a waterproof ring, pls set the distance 90cm between the ring and the pole head, Lamp pole diameter of 60 mm

【2】Use 6mm hex wrench loose this four screw，move the power supply cover.

【3】Pls insert the cable into the pole after finished the connection.

【4】Install the lamp on the pole

【5】Put the power supply cover，Use hex wrench tight the four screw

【6】Connect Live Wire/Null Wire/Ground Wire to electric cable properly and switch on.

2、After above operation finished, and then connect power supply.

3、Maintenance & repair instructions

1）. Troubles resolution:

Troubles and solutions: Observe the surface of LED light source whether there is discoloration, broken traces, with or without obvious fracture connectivity when you check. Please also check whether Power connection is loose & short-circuit, with or without obvious signs of damage. Please replace the light source and power if there is any obvious signs of damage.

LED lamp not bright

Lamp wire connection is abnormalLoosen the screw and reconnect the power supply wire

LED   is damagedReplace the LED

Power supply failure   Replace the power supply
LED lamp twinkled

Power supply connected well   Loose the screw and reconnect the power supply wire

Input voltage waves large    Confirm the right input voltage

Power supply failure   Replace power supply

2） Maintenance, repair Note

1）、Please make sure the power-off before the maintenance。

2）、In order to maintain a good light transmittance, please clean the reflector of the industrial light regularly.

3）、For maintaining good heat dissipation, please clean the dust on shell and the heat sink of the industrial light timely.

4）、Please do not use water or corrosive cleaning liquor to clean, preferably with a dry cloth.

5）、You may open the rear cover with a screwdriver, cut off the power when you replace the power supply. About the AC power three-pin wire, the brown one is “L”, the blue one is “N”, the green & yellow one is Ground line. Regarding DC power wire, the red or white lines correspond to anode, and the black line corresponds to cathode. Please don’t reverse the anode and cathode.